That has lead to me making my own lactose free Greek yogurt and freeze drying it to use for yogurt and sour cream for my son. We also freeze dry lactose free milk for traveling or for any other time we need it. It reconstitutes very well.
The shelf heaters can be set to automatically control the rate of sublimation during the primary drying cycle.
. We have some really great 'techy' type guys here who are, as they have been exploring the FD mechanics and sharing that in their posts, writing what is turning out to be a 'troubleshooting manual' for us less capable folks.
Tony, if you see this, I went ahead and purchased the catch can. Do you think it's okay to just purchase a reducer to go from the size of the exhaust to the size of the hose that came with the can?
As I've shown you, the Small Harvest Right Freeze Dryer is the most affordable freeze dryer. However, if that's not what appeals to you, I know you can't go wrong with the other models. After all, I own the large model.
Adopting such technologies puts these businesses in a better position to meet regulatory standards and makes them more viable in the market.
1) I installed a 3/4" wide high density closed cell foam in the gap between the front of the chamber and the back of the front panel - just what Harvest Right suggested except all the way around (the first picture shows the gap). Use your fingers to push it into place. It needs to be tight against the inside panel. I then installed a vapor barrier around the entire FDer chamber. I used 7mil plastic and clear packing tape.
The pros and cons are easy to understand. In fact, there really is only one pro and it’s a huge one. YOU control the food you’re storing away for yourself and your family. Those who are willing to spend the time and money to freeze dry their own food should do Home Small Pro Freeze Dryer so as long as they’re going to be committed.
A description of the product, including details such as build quality, materials used and reasons to purchase.
The alternative was to simpIy cut a small section from the guard at the lowest point and allow the water to run down the front of the panel in a single stream. I am not crazy about the look, but it is absolutely necessary to protect my investment and the electronics. If you look carefully you can see the hole in the gutter beneath the center screw.
Never allowing the unit to heat up to ambient temps - Quickly removing the ice from the chamber and starting the next cycle while the chamber unit is still very cold.
Granted, most of that time is the freeze dryer doing all the work, but the process is not without effort. Once the food is more info ready it must be put into appropriate containers with oxygen absorbers and sealed properly so they can last.
Monitoring the FDer internal temps and once I see -40F I start the dry cycle, except for high sugar content food which I give an Em excesso hour. I'm still experimenting with Ice cream and a few fruits to determine optimal freeze time to get the best results. The cooling cycle ends up much shorter.
I started by removing the 3 grocery bags that were holding the 2 thick bags that had at one time held the berries. Struck by how much it looked like a placenta - bag and all!